Mitsubishi Electric MELDAS 600M Series, Инструкция по эксплуатации

Страница: 504 / 512

CHAPTER 4 APPENDICES
Appendix 4. Warning Messages
IV
– 62
No. Message Details Remedy
OPW0165 Chopping rot
axis invalid
Chopping operation of the
rotation axis was attempted.
•
Chopping cannot be commanded
to the rotation axis.
OPW0166 Invalid Ope in
NURBS mode
An illegal operation was carried
out during NURBS interpolation.
•
Do not carry out MDI interrupt,
etc., during NURBS interpolation.
OPW0167 F1 Feed Rate
Zero
When the F1-digit feed
command was executed, the
F1-digit feedrate was zero.
•
Set the F1-digit feedrate on the
user parameter screen.
•
Accelerate the speed with the
manual handle.
OPW0168 Ref.pnt ret
cancel tool offset
Zero point return was carried out
during tool evasion return, so the
tool offset after zero point return
was invalidated.
•
To reset the error, change the
operation mode to a mode other
than zero point return before the
axis returns to the zero point.
•
The error will be reset when the
tool return is completed.
•
The error will be reset when reset
1 is input or emergency stop is
applied.
OPW0169 Rotate work
compen
excessive
The rotary axis workpiece
position compensation amount
exceeded 3mm.
•
Turn the rotary axis workpiece
position compensation OFF.
•
Set the deviation between the
workpiece center position and
table rotation center to 3mm or
less.
•
Check that the workpiece
coordinate zero point is set at the
workpiece center.
OPW0170 External
deceleration axis
More than one axis moves at the
external deceleration speed.
•
Invalidate external deceleration.
Downloaded from ManualsNet.com search engine