Mitsubishi Electric MELDAS 600M Series, Инструкция по эксплуатации

Страница: 505 / 512

CHAPTER 4 APPENDICES
Appendix 4. Warning Messages
IV
– 63
4.6 Program warnings (PRW )
No. Message Details Remedy
PRW0001 Overlap address
exists
Because the No. of addresses
that can be simultaneously
commanded in one block was
exceeded, the previously
designated address was
ignored.
No. of addresses that can be
simultaneously commanded in
one block :
M = Max. 4 addresses.
Other than M = 1 address
•
Reconsider the program.
PRW0002 Overlap G code
exists
Because several G codes were
commanded in the same group,
the previously designated G
code was ignored.
•
Reconsider the program.
PRW0003 Ignored G code
exists
A G code exists that was
ignored due to a G code priority
order check.
•
Reconsider the program.
PRW0004 Unused address
exists
An address exists that was not
used in the program block.
•
Reconsider the program.
PRW0005 Ref point ret in
pattern rot
Reference point return was
attempted while rotating the
figure.
•
Reconsider the program.
PRW0006 No end point
operation in arc
There is no end point coordinate
command for the R-designated
arc.
•
Reconsider the program.
PRW0007 Cylinder mode
warning
A command illegal for the
cylindrical mode was issued.
•
Reconsider the program.
Downloaded from ManualsNet.com search engine