Mitsubishi Electric MELDAS 600M Series, Инструкция по эксплуатации

Страница: 258 / 512

CHAPTER 1 SCREEN OPERATIONS
4. Edit Screens
I
– 243
4.2 Editing operations
When the program is edited, the key input data is directly written into the program display area. All data is
overwritten from the cursor position. The message "Editing" appears simultaneously with the start of
inputting. (The message disappears when the file is saved.)
If the cursor is at "%" and the
INPUT
key is pressed, EOB (;) is added to the end of the line.
The method of saving into the memory differs according to the operation parameter "370040 Program
save type" setting.
When the program save type is 0:
If the menu key
Save file
is pressed, the file is saved in the memory.
The message "Editing" does not disappear when the
INPUT
key is pressed.
When the program save type is 1:
The file is saved in the memory each time the
INPUT
key is pressed.
The message "Editing" disappears when the
INPUT
key is pressed.
The editing operations from when the file is actually opened, or in other words, the methods of changing
the display and editing (inserting, deleting, copying, pasting, searching and replacement methods) are
explained in this section.
These editing operations are common for the machining program and MDI program.
Caution
!
If there is no value after the G command, the operation will be the "G00" operation when the
program is run due to key chattering, etc., during editing.
Downloaded from ManualsNet.com search engine