Mitsubishi Electric MELDAS 600M Series, Инструкция по эксплуатации

Страница: 99 / 512

CHAPTER 1 SCREEN OPERATIONS
2. Monitor (Operation) Screens
I
– 84
Notes for checking (Common for continuous check and step check)
1) If the menu key
Display range
is pressed while drawing in the trace or check mode, the
drawing stops. The drawing resumes when the selected function is completed. Note that in the
trace mode, the area executed while stopped is not displayed.
However, the display up to this point is erased when the range is changed.
2) During the trace and check modes, the drawing continues even if another screen is changed
to.
3) If the automatic start button is pressed during the check, the operation alarm "Program
checking" appears while the button is held down, and automatic start is inhibited.
Execute automatic start after completing the check or after stopping the check by pressing the
Check reset
.
4) The check mode ends when reset, the trace display is turned ON, etc.
If a program error occurs, cancel the error with these operations.
5) Refer to "(6) Variables, parameters, and offsets" for details on handling the various data set in
the program being checked.
6) If an M00/M01 command is found, "Program stopped" is applied. However, when an M01
command is executed, the drawing stops regardless of the ON/OFF state of the optional stop
switch signal.
When various menu keys are pressed during continuous check or step check
1) If
Check continu
is pressed during the continuous check, the program check stops.
If
Check continu
is pressed while stopped, the program check resumes.
2) If
Check step
is pressed during the continuous check, the menu highlight changes from
Check continu
to
Check step
, and the program is checked one block at a time.
3) If
Check reset
is pressed during the continuous check, the mode is canceled after the
currently executed block is completed.
4) If
Check continu
is pressed during step check, the menu highlight changes from
Check step
to
Check continu
, and the program is continuously checked.
Notes for ending check
1) If an M02/M30 command is found, "Program check completed" occurs. Note that in the tape
mode (RS-232C), the tape is not rewound.
2) The check mode ends when reset, the trace display is turned ON, etc.
Downloaded from ManualsNet.com search engine