Maschio EXTREME 266 HTC, Использование и обслуживание

Страница: 94 / 240

ENGLISH
USE AND MAINTENANCE
Page 92 Cod. F07022408
ADJUSTMENT OF THE PICK-UP WHEELS
It is possible to adjust the working height of the pick-up:
o raise or lower the height of the pick-up change the position of the pin "S", located on the support wheel arm, by
inserting it into one of the holes located on the side of the pick-up to give the working height required.
Move the pin following the indications on the decal located on the protection guard of the pick-up:
•
Towards the decal "+": pick-up lower.
•
Towards the decal "-": pick-up higher.
IMPORTANT!
Insert the pin "S" in the same position on both left
and right sides of the pick-up.
To raise or lower the pick-up:
•
Use the lever of the tractor switch remembering to open the stop valve
located near the quick release fitting (position "OPEN").
OPEN
IMPORTANT!
The tines of the pick-up must never touch the ground; therefore adjust the working height of the pick-up
so that the tines remain at least 2-3cm (0ft 0.78in - 0ft 1.18in) above the ground.
Before reversing, the pivoting wheels must be raised from the ground by raising the pick-up in order not
to damage them.
H minimum= 2÷3 cm
For further information regarding the adjustment of the pick-up working height, refer to the paragraph
“ADJUSTMENT OF THE PICK-UP”.
S
H