Maschio EXTREME 266 HTC, Использование и обслуживание

Страница: 114 / 240

ENGLISH
USE AND MAINTENANCE
Page 112 Cod. F07022408
Visualizations during collecting phase (pre-chamber core bale):
•
PTO SPEED (364 RPM in example above).
•
SIDE BARS OF LOADING CHAMBER SENSORS: show to the operator the
machine side that has to be loaded more to maintain uniform pressure in the
bale;
•
FORMING BALE DIAMETER
Once the forming bale has reached the minimum size of the room, the above screen
is replaced by the following one; the machine continues the bale formation,
according to the program settings.
NOTICE: If, after the placement of the rocker arm, the hydraulic circuit is still
enabled, pushing the rocker arm below the diameter of the pre-chamber, the system
displays the following error message to indicate that pre-chamber settings are gone
and is forming a bale with a hard core. To turn the rocker arm back in the pre-
chamber position you need to perform the opening and closing door commands.
NOTE: Once reached 90% of the tying pressure value set in the program, an intermittent sound signal starts.
NOTICE: If the pressure exceeds the tying pressure value set in the program, both a sound and a visual indication
start, to show to the operator that he must stop the vehicle (and start tying):
In case of manual cycle, with tying that shall be started by the operator, the view
remains fixed in the area and the icons and are shown next to the
designed key, to indicate to the operator which key to press to start the binding
phase of the bale.
In case of automatic cycle, after displaying the message which asks to the operator to stop the vehicle, the tying
phase starts.