Maschio EXTREME 266 HTC, Использование и обслуживание

Страница: 168 / 240

ENGLISH
USE AND MAINTENANCE
Page 166 Cod. F07022408
ICON CONTROL SYSTEM
PROBLEM POSSIBLE CAUSE SOLUTION
After pressing the on/off Key the display
does not light up. Feeder cable from the battery not
connected to the machine cable. Connect the male COBO plug of the
machine cable to the female COBO
socket of the feeder cable connected to
the battery. Check that the clip of the
female connector is inserted in the slot
of the male connector to ensure a
secure connection.
Data transmission cable not connected
to the terminal. Insert the connector of the data
transmission cable in the female socket
of the terminal.
Secure it by screwing.
Inverted polarity. Invert the cable connections on the
terminal blocks of the battery: the red
cable provided with a fuse should be
attached to the positive "+" clip, the
black cable to the negative "-" clip.
Oxidised contacts on the tractor
battery. Carefully clean the clips. And check the
condition of the battery.
The voltage produced must be 12V
minimum.
Fuse burnt out or missing. Check that the fuses on the battery
cable are intact.
A message appears on the display
"Battery insufficient". Low voltage. Check the battery or the recharging
system of the tractor.
A message appears on the display
"Bale binding not correct". The net have not been taken by the
bale. Find and eliminate the cause, then
restart the binding by pressing the
"START-STOP" button.
The net breaks before finishing the
binding or wrapping.
The net have run out before finishing
binding/wrapping.
A message appears on the display
"PTO blocked during binding".
The PTO of the tractor is not moving. Engage the PTO.
The PTO sensor is badly adjusted. Adjust the sensor.
The sensor is broken or defective. Replace the sensor.