Maschio EXTREME 266 HTC, Использование и обслуживание

Страница: 192 / 240

ENGLISH
USE AND MAINTENANCE
Page 190 Cod. F07022408
ELECTRICAL AND ELECTRONIC COMPONENTS
•
Check that the cables of the electrical system and the control unit have not been crushed or damaged.
•
Check that all the sockets, plugs, cables and sensors are always cleaned of any deposits of earth or the
product.
•
Check and if necessary replace broken bulbs in the lighting system.
IMPORTANT!
After the first 200 bales produced check the machine in regard to the points described above.
SENSORS
A series of “proximity switches” (sensors) have been placed on the round baler. These regulate and monitor the
various working phases of the machine through the “ICON” system.
Adjust the distance "X" (circa 1÷3 mm – 0ft 0.03in÷0ft 0.11in) between the sensor "S" and its abutment "R", as
shown in the figure (the example is only indicative):
•
With the “ICON” control system switched on, turn
the nuts that fix the sensor to its support in order
to move it closer to or further from its abutment.
•
When the "LED" light located on the sensor comes
on this means that you have obtained the right
distance "X".
•
Then secure the nuts and check that the "LED" of
the sensor still comes on as the sensor may have
been moved again when the nuts were tightened.
X = 1÷3 mm (0ft 0.03in÷0ft 0.11in)
IMPORTANTE!
Adjust the sensors so that they never touch or collide with their abutments when working.
CAUTION!
DANGER OF GETTING CAUGHT IN MOVING PARTS OF THE MACHINE.
POTENTIAL CRUSHING OR SHEARING OF THE LIMBS.
POTENTIAL SERIOUS INJURIES OR DEATH.
Make all the adjustments on all the sensors located on the machine observing the safety regulations and
taking great care at the points where there could be particular danger.
•
Stop the machine and wait for all the moving parts to stop.
•
Turn off the tractor engine and remove the keys from the dashboard
If it should be necessary, in order to gain access to the sensors, to open or remove the guards, remember always
to close them and reposition them after finishing the adjustments.
S
R
LED
X