Maschio EXTREME 266 HTC, Использование и обслуживание

Страница: 109 / 240

USE AND MAINTENANCE
ENGLISH
Cod. F07022408 Page 107
STOPPING THE MACHINE
IMPORTANT!
On finishing work the operator must:
•
Stop the machine.
•
Make sure that all the moving parts of the machine have stopped and are in the rest position.
•
Stop the tractor motor and remove the keys from the dashboard.
•
Switch off the “ICON” system.
PARKING
CAUTION!
DANGER OF MACHINE FALLING.
CRUSHING HAZARD.
POTENTIAL SERIOUS INJURIES OR DEATH.
Before taking the machine back to its storage area make sure that there is no bale still loaded..
At the end of work deposit the machine in a suitable flat area to avoid sudden accidental movement
•
Place the parking chocks under the wheels or, if installed on your machine, use the mechanical parking
device..
•
Lower the parking jack to the ground and block it with the safety pin. Raise the machine by 2÷3 cm (0ft
0.78in÷0ft 1.18) from its connection to the tractor in order to unhook it.
•
Raise the cardan shaft support, then disconnect the cardan shaft from the tractor and rest it on the support.
Secure it with the chain.
•
De-pressurise hydraulic circuit and:
•
Rest the small wheels of the pick-up on the ground; move the lever of the stop valve to the "CLOSED"
position; then disconnect the tube and place it in its special support.
•
Disconnect all the other tubes of the hydraulic system and place them in its special support.
•
Disconnect the electrical feed lines, from the lighting system and wrap them around the support.
•
Disconnect the signal cable of the “ICON” system and wrap it around the tube support.
Then remove the control terminal, place it in its box and put it in a place protected from dust and adverse
weather conditions.
•
Remove the safety pin and the locking pin from the towing eye of the steering bar and then unhook the tractor
from the machine.
•
Remove the tractor from the vicinity of the baler.
•
Install the device against unauthorised use on the towing eye.