Maschio EXTREME 266 HTC, Использование и обслуживание

Страница: 123 / 240

USE AND MAINTENANCE
ENGLISH
Cod. F07022408 Page 121
3) CUT STATUS
VISUALIZATIONS
The icon displays the status of the cut groups:
= CUT: cut groups outside the chamber;;
= CUT ON: cut group inside the chamber.
COMMANDS
Pressing the side key near to this icon, you can access the “CUT MANAGEMENT” page in the “MANUAL MODE”
menu, where it’s possible to manage the cut group.
4) AUTOMATIC / MANUAL TYNG
VISUALIZATIONS
Tying cycle starting mode (automatic or manual).
COMMANDS
-
Pressing the side key near to this icon, the tying starting mode toggles between the two modes.
5) START TYING
VISUALIZATIONS
NOTE: The tying start icon in manual or automatic mode will be different depending on the type of binding
used:
NET =
TWINE =
TWINE-NET =
Different START icon, based on tying starting mode, automatic or manual .
COMMANDS
Press the side key near to this icon to start tying cycle.
When manual mode is selected, the operator uses this key to start tying.
When automatic mode is selected, tying cycle starts after the bale pressure has reached the tying pressure set in
the program.
Even in automatic mode, the key near to the icon starts the tying phase.