Maschio EXTREME 266 HTC, Использование и обслуживание

Страница: 154 / 240

ENGLISH
USE AND MAINTENANCE
Page 152 Cod. F07022408
VISUALIZATIONS (page 5)
•
Forming bale diameter value (cm);
•
Direct check of the diameter sensor;
•
PAGE NO. / TOTAL PAGES;
COMMANDS (page 5)
Press side keys next to the symbol that represents the menu to see the name of the menu for about 2 seconds.
Press the side key near to the icon to activate the wizard to run the maximum diameter self-learning
procedure. During the procedure, the operator is asked to fully open the door and then close it again. Any
anomalies in the procedure will be identified with appropriate diagnostic messages
Note that the execution of self-learning procedures and maximum diameter calculation override the parameters
values that regulate the function: Run only if really necessary.
Press the side key near to the icon , to activate the wizard to calculate the maximum diameter of the machine
according to the sizes detected from the last bale. During the procedure, the operator is asked to measure the
last produced bale and to enter the value by pressing the side keys near to the icons and . After entering the
value, press
to confirm or to cancel. To access the procedure you need to have formed at least a bale
before.
Pressing the button next to the icon , depending on the access level defined by the password you entered,
some characteristic parameters of the page are displayed;
•
Press the side key near to the icon to access the previous page;
•
Press the side key near to the icon to access the next page
•
Press the key below the icon to go back to previous menu;