ENGLISH
USE AND MAINTENANCE
Page 24
Cod. F07022408
The heating of tubes containing fluid under pressure can cause a spray of flammable
vapour, causing severe burns to the person working and to people around.
During welding or brazing operations or when using open flames, do not heat the
areas near the pressurised fluid tubes or other flammable materials. The heat in the
area just beyond the tip of the flame can cause the accidental explosion of
pressurised tubes.
During these operations, the use of suitable PPE is recommended.
Removal of paint before welding or heating. Avoid potentially toxic fumes and dust.
The heating of paint during welding operations or when using a flame can generate
hazardous fumes.
During these operations, the use of suitable PPE is recommended.
Before heating:
•
Remove paint over an area of at least 100mm in diameter around the point that will be affected by heating. If
you cannot remove the paint before heating or welding, wear an approved respirator.
•
Do not breathe in dust when you sand or grind paint.
Wear an approved respirator.
•
If using a solvent or paint stripper, remove residues with soap and water before starting welding operations.
Keep solvent or paint stripper containers away from other flammable material.
•
Allow fumes to disperse for at least 15 minutes before welding or heating.
Do not use chlorinated solvents in welding areas.
Perform all work in a well-aerated area where toxic fumes and dust can be vented.
Properly dispose of paint and solvent.
Use the oils advised i.
•
Carry out the maintenance scrupulously according to this manual and have worn or
damaged parts replaced by specialised personnel.
Spare parts must correspond to the requirements established by the manufacturer.
USE ORIGINAL SPARE PARTS ONLY
Use only the cardan shafts indicated by the manufacturer of the machine
This operator manual with instructions for using the round baler must be read memorised and kept for
the entire life of the machine.
MASCHIO FIENAGIONE declines all liability deriving from failure to observe these warnings.
Содержание EXTREME 266 HTC
