Maschio EXTREME 266 HTC, Использование и обслуживание

Страница: 166 / 240

ENGLISH
USE AND MAINTENANCE
Page 164 Cod. F07022408
BINDING
PROBLEM POSSIBLE CAUSE SOLUTION
The turns become loose at the ends of
the bale. The number of turns is insufficient at
the ends of the bale, Do at least two complete turns on each
side of the bale.
The position of the twine guiding tubes
on the sides is not correct, too far out. Adjust the lateral limits by moving the
end of stroke of the binder.
Binding of the central part insufficient. The twine guiding arm moves too
quickly. Reduce the speed of the binder's
electrical
actuator movement by
changing the value set on the control
unit.
The twine is not drawn by the bale. The ends of the twine that protrude
from the tubes of the twine guiding arm
are not long enough. Make the twine dangle by a length of at
least 20cm.
The twine does not pass freely.
Adjust the tension of the springs of the
twine braking device and check the
path of the twine.
The points of passage of the twine are
blocked with dirt or forage. Check and clean all the points of
passage of the twine.
The twine is not cut correctly. Replace the blade or adjust the blade
support.
The twine is not cut. The blade is worn.
Turn the blade of the twine cutter
around or replace it.
The twine does not pass the twine
cutter blade. Adjust the stopping screw of the blade
support.
The twine does not run over the
pulleys.
The twine is knotted in a tangle. Unravel the tangle.
The twine is not wrapped around the
pulley. Wrap the twine around the pulley.
The twine running sensor is badly
adjusted. Adjust the sensor.
The sensor is broken or defective. Replace the sensor.
The net does not start to wrap the bale. The end of the net does not protrude
enough. Make the net dangle at least 20cm.
The adjusting retainers of the net arm
are not adjusted correctly. Adjust the retainers so as to allow the
net arm to approach the roller.
The net is not cut correctly. The cutting edges of the blade sections
are worn away. Sharpen the blade sections.
The net roll has insufficient braking. Increase the braking by adjusting or
shimming the lateral spring tie-rods.
The net arm does not stop to release
the required metres of net. The sensor of the net arm is badly
adjusted. Adjust the sensor.
The sensor is broken or defective. Replace the sensor.
The metres of net do not come down. The net counter sensor is badly
adjusted. Adjust the sensor.
The sensor is broken or defective. Replace the sensor.