Canon IMAGERUNNER 7095 PRINTER, Руководство по обслуживанию

Страница: 77 / 615

Chapter 2
2-30
2.2.21 Switching Over the Paper Size for
the Front Deck (right, left)
0010-8997
1) Press the front deck release button, and slide
out the deck.
2) Remove the screw [2] of the rear guide plate
[1], and fix the guide plate in place to match the
size specified by the user.
F-2-120
3) Remove the screw [2] from the left/right guide
plate [1], and fix the guide plate in place to
match the size specified by the user.
F-2-121
4) Put paper in the front deck.
5) Close the front deck.
6) Choose the appropriate deck size label [1] from
the backing paper (cassette/deck), and attach it
to the paper size plate of the deck.
F-2-122
7) Start service mode, and register the front deck
paper size.
MEMO:
right deck: COPIER > OPTION > CST > P-SZ-
C1
left deck: COPIER > OPTION > CST > P-SZ-C2
A4=6, B5=15, LTR=18
8) When done, go through the shut-down
sequence to turn off and then on the main
power.
2.2.22 Checking the Operation in a
System Configuration
0011-4297
1) Install the accessories according to their
respective Installation Procedures.
2) Check to make sure that all accessories have
been connected correctly.
- Make a check in service mode:
Start service mode, and make the following
selections: COPIER > OPTION > ACCPST-
D > ACC1 through 8.
Check to see that the order and the model
names are indicated correctly.
End service mode.
- Click 'system status/stop' to check the device
information.
Check to make sure that all connected
accessories are indicated.
3) Check the operation using the accessories.
- Make sure paper does not jam, move askew,
or fail to deposit properly.
[1]
[2]
[1]
[2]
[1]