Canon IMAGERUNNER 7095 PRINTER, Руководство по обслуживанию

Страница: 230 / 615

Chapter 7
7-53
11) Mount the wire cleaner. At this time, pay
attention to the orientation of the wire cleaner.
12) Wipe the charging wire with lint-free paper
moistened with alcohol.
7.10.19.5 Stringing the Grid of the
Primary Charging Assembly
0010-8942
1) Check to make sure that the 4 screws used to
keep the front/rear block and shielding plate are
not loose.
Then, hook the end of the charging wire on stud
A, and then route it for 41 runs; then, hook it on
B, C, and D; thereafter, fit it between the double
washers [1], give a 1/2 turn around the screw
[2], and secure it in place.
F-7-138
2) Loosen the screws [1], [2], [3], [4]; then,
tighten the screw [5] to a torque of 1.5 -/+0.2
kg-cm. thereafter, tighten the screws [1], [2],
[3], [4] to a torque of 8 kg-cm in the order
indicated.
F-7-139
7.10.19.6 Adjusting the Height of the
Charging Wire
0010-8945
T-7-3
MEMO:
The height (position) of the primary and transfer
charging wires may be adjusted by turning the
screw found at the rear of the charging assembly.
A full turn of the screw changes the position of
the charging wire by about 0.7 mm.
A
B
C
[1] [2] D
[1]
[2]
[3]
[4]
[5]
Height of charging wire
Primary
Pre-transfer
Separation
Transfer
7.5
- 0mm
+3mm
7.5
- 0mm
+3mm
13.6 ±0.3mm
No height adjusting
mechanism
17.0 0.2mm
15.5 0.2mm
9.0 0.2mm