Canon IMAGERUNNER 7095 PRINTER, Руководство по обслуживанию

Страница: 446 / 615

Chapter 16
16-12
1001 An initialization error has occurred at the start of a job. Reset the PDL mechanism. Turn off and
then on the power.
100A An error has occurred in the communication with an
external controller.
9004 A fault has been detected in the cable connection with
an external controller. Turn off and then on the power. Replace
the external controller relay PCB. Replace
the
external controller.
9005 A fault has been detected in the cable connection with
an external controller.
A006 The PDL mechanism does not respond. Reset the PDL mechanism. Turn off and
then on the power. Reinstall the system
software.
Replace the main controller.
A007 At start-up, the version of the machine control
software and that of the PDL control
software do not match. Reset the PDL mechanism. Turn off and
then on the power. Execute full formatting
of the
HDD, and reinstall the system software.
B013 The font data is corrupted at start-up. Turn off and then on the power. Reinstall
the system software. Execute full
formatting of
the HDD, and reinstall the system
software.
E732 An error has occurred in the communication between the reader unit and the main
controller.
0001 An error has occurred in the communication between
the reader unit and the main
controller. Disconnect and connect the connectors of
the read communication cable. Check the
power supply of the reader unit (to see if
initialization occurs at power-on). Replace
the
reader controller PCB. Reap the reader I/F
PCB. Replace the main controller PCB.
0010 A fault has been detected in the reader sync signal
detection mechanism.
E733 An error has occurred in the communication between the reader unit and the main
controller.
0000 An error has occurred in the communication between
the reader unit and the main
controller. Disconnect and then connect the
connector. Check the power supply of the
DC controller (to
see if initialization occurs at time of start-
up). Replace the DC controller PCB.
Replace the
main controller PCB.
0001 An attempt to communicate with the DC controller
fails.
0010 A fault has occurred in the printer engine sync signal
detection mechanism.
E740 An error exists in the LAN controller.
0002 An illegal MAC address has been detected at start-up. Replace the main controller PCB.
E743 A fault exists in the communication between the main controller and the reader controller.
0000 The reader controller has detected an error in the
communication between the main
controller and the reader controller. Disconnect and then connect the
connectors of the reader communications
cable. Replace
the reader controller PCB. Replace the
main controller PCB.
E744 An error exists in the language file/boot ROM.
Code Description Remedial action
*: model equipped with DADF-Q1 (outside Japan, iR7105/7095; inside Japan: iR7105/7095/7086).
**: model equipped with DADF-M1 (outside Japan: iR7086).