Beckman Coulter Navios, Инструкция по эксплуатации

Страница: 513 / 586

773232AH
13-21
Troubleshooting
Cytometer Messages Table
13
Red Laser Initializing The red laser is initializing. If the laser does not initialize within a
reasonable time then restart the entire
system. If the problem persists then contact
your local Beckman Coulter Representative.
Red Laser Not Calibrated The instrument is not calibrated to
trigger off the red laser. Calibrate the red laser.
Red Laser Power Error During acquisition the red laser
output power went out of range and
the acquisition was stopped. If the error persists, contact your local
Beckman Coulter Representative.
Red Laser Power Warning The red laser power is unstable. If laser does not stabilize within a
reasonable time or frequently goes unstable
then restart the entire system. If the
problem persists then contact your local
Beckman Coulter Representative.
Sample Pressure Error During acquisition the sample
pressure went out of range and the
acquisition was stopped. If the error persists, contact your local
Beckman Coulter Representative.
Sample Pressure Warning The sample pressure is outside the
operating range. If warning persists, see Sample Pressure
Error.
Sample Tube Not Found No tube is present in the carousel
location identified in Acquisition
Manager. Verify the intended sample is placed in the
location identified in Acquisition Manager
and select Run.
Sample Tube Pressure Error After several attempts the sample
tube could not be pressurized. There
may be a leak caused by a bad
sample tube or a bad sample head. Inspect sample tube and sample head for
damage. Change as required. See
Replace
The Mcl Sample Head .
Sample Tube Pressure Warning The first attempt to pressurize the
tube failed. There may be a leak
caused by a bad sample tube or a
bad sample head If warning persists, see Sample Tube
Pressure Error.
Sampler Board Not Found The sampler I/O board could not be
detected. Restart the entire system. If error persists,
contact your local Beckman Coulter
Representative.
Sampler I/O Board Voltage Error The voltages on the sampler I/O
board are out of range. Restart the entire system. If error persists,
contact your local Beckman Coulter
Representative.
SCA Board 1 Missing The data acquisition board SCA 1
could not be detected Restart the entire system. If error persists,
contact your local Beckman Coulter
Representative.
SCA Board 2 Missing The data acquisition board SCA 2
could not be detected Restart the entire system. If error persists,
contact your local Beckman Coulter
Representative.
SCA Board 3 Missing The data acquisition board SCA 3
could not be detected Restart the entire system. If error persists,
contact your local Beckman Coulter
Representative.
Table 13.2
Cytometer Messages
(Continued)
Message Probable Cause Recommended Action