Arctic Cat 650 Twin2004, Руководство по обслуживанию

Страница: 67 / 210

3-38
Joining Crankcase
Halves
A. Breather Tube
B. Positioning Bolt
C. Drive Bevel Gear (Assembling)
D. Driven Bevel Gear (Assembling)
E. Drive/Driven Bevel Gears
(Installing)
F. Backlash (Adjusting)
G. Tooth Contact (Adjusting)
H. Camshaft Drive Chains
(Installing)
I. Intermediate Shaft
1. Apply Three Bond Sealant (p/n 0636-070) to the
mating surface of the left crankcase half (A) being
careful to keep sealant out of the oil passage (B);
then join the crankcase halves.
ATV2083
2. Apply blue Loctite #242 to the thread area (C),
except tip (D) of left case cap screw (3); then
install and tighten the 8 mm cap screws to 2.0
kg-m (14.5 ft-lb) following the tightening
sequence 1-8. Tighten the 6 mm crankcase cap
screws (A) and (B) to 1.0 kg-m (7 ft-lb).
ATV2084A
ATV2085
3. Install the breather tube (A) on the crankcase
fitting aligning the white line on the tube with the
mark (B) on the crankcase; then install the clamp
(C) directing the open end toward the left side (D)
of the crankcase.
ATV2086
4. Apply grease to the steel ball (A) and spring (B);
then install the steel ball, spring, washer (C), and
shift shaft positioning bolt (D). Tighten the shift
shaft positioning bolt to 2.5 kg-m (18 ft-lb).
ATV2087
5. Check that the crankshaft and driven shaft turn
freely. If any of the shafts don’t turn freely,
separate the crankcase halves to locate the
problem.
6. Using the bearing driver (A), drive the bearing
into the housing until it bottoms out.