Arctic Cat 650 Twin2004, Руководство по обслуживанию

Страница: 21 / 210

2-12
Steering Components
The following steering components should be
inspected periodically to ensure safe and proper opera-
tion.
A. Handlebar grips not worn, broken, or loose.
B. Handlebar not bent, cracked, and has equal and
complete full-left and full-right capability.
C. Steering post bearing assembly/bearing hous-
ing not broken, worn, or binding.
D. Ball joints not worn, cracked, or damaged.
E. Tie rods not bent or cracked.
F. Knuckles not worn, cracked, or damaged.
G. Cotter pins not damaged or missing.
Driveshaft/Coupling
The following drive system components should be
inspected periodically to ensure proper operation.
A. Spline lateral movement (slop).
B. Coupling cracked, damaged, or worn.
Suspension/Shock
Absorbers/Bushings
The following suspension system components should
be inspected periodically to ensure proper operation.
A. Shock absorber rods bent, pitted, or damaged.
B. Rubber damper cracked, broken, or missing.
C. Shock absorber body damaged, punctured, or
leaking.
D. Shock absorber eyelets broken, bent, or
cracked.
E. Shock absorber eyelet bushings worn, deter-
iorated, cracked, or missing.
F. Shock absorber spring broken or sagging.
Nuts/Bolts/Cap Screws
Tighten all nuts, bolts, and cap screws. Make sure riv-
ets holding components together are tight. Replace all
loose rivets. Care must be taken that all calibrated
nuts, bolts, and cap screws are tightened to specifica-
tions. For proper torque values, see Section 10.
Ignition Timing
The ignition timing cannot be adjusted; however, veri-
fying ignition timing can aid in troubleshooting other
components. To verify ignition timing, see Section 5.
Headlight/Taillight-
Brakelight
Each time the ATV is used, lights should be checked
for proper function. Rotate the ignition switch to the
lights position; the headlights and taillight should illu-
minate. Test the brakelight by compressing the brake
lever. The brakelight should illuminate.
HEADLIGHT

NOTE: The bulb portion of the headlight is frag-
ile. HANDLE WITH CARE. When replacing the
headlight bulb, do not touch the glass portion of
the bulb. If the glass is touched, it must be cleaned
with a dry cloth before installing. Skin oil residue
on the bulb will shorten the life of the bulb.
To replace the headlight bulb, use the following proce-
dure.
1. Remove the wiring harness connector from the
back of the headlight bulb assembly.
2. Grasp the bulb assembly and turn it counterclock-
wise to remove the bulb assembly from the hous-
ing.
3. Install the new bulb assembly into the housing and
rotate it completely clockwise.
4. Install the wiring harness connector.
! WARNING
Do not attempt to remove the bulb when it is hot.
Severe burns may result.