Arctic Cat 650 Twin2004, Руководство по обслуживанию

Страница: 126 / 210

5-25
5
ATV2146
Output-to-Speed
Sensor Voltage
Select D.C. Voltage on the multimeter (B), disconnect
the speed sensor connector, and turn the ignition
switch ON; then connect the red meter lead to the
pink/white wire terminal (5) and the black tester lead
to the black wire terminal (10) in the controller (A).
The meter should read 5 ± 0.25 D.C. volts. If the read-
ing is not as specified, replace the actuator controller.
ATV2147
Speed Sensor Signal
Voltage
1. Support the ATV on a stand or suitable jack so the
wheels are off the ground; then turn the ignition
switch ON.
2. Select D.C. Voltage on the multimeter (B); then
connect the red tester lead to the pink/white wire
terminal (5) and the black tester lead to the black
wire terminal (10) in the controller (A).
ATV2147
3. Spin a rear wheel in the forward direction while
observing the multimeter. The meter should
alternately show 0 volts and 5 D.C. volts. If the
reading is not as specified, replace the speed
sensor.
Tilt Sensor Voltage
SUPPLY VOLTAGE
1. Disconnect the three-wire connector (A); then
select D.C. Voltage on the multimeter (B) and
connect the red tester lead to the orange wire
terminal (C) and the black tester lead to the black
wire terminal (D) (harness side).
KX043A
! WARNING
Incorrect installation of the tilt sensor could cause
sudden loss of engine power which could result in
loss of vehicle control resulting in injury or death.
! CAUTION
Do not drop the tilt sensor as shock can damage
the internal mechanism.