Arctic Cat 650 Twin2004, Руководство по обслуживанию

Страница: 100 / 210

4-17
4
KX192
3. Turn the ignition switch to the ON position. The
fuel pressure should build until the pump shuts off.
Pressure should read 0.18-0.23 kg-cm
2
(2.6-3.3
psi).
4. If the pump is not running, disconnect the fuel
pump/tank sensor connector by reaching under the
rear rack from behind.
5. Connect a multimeter to the power supply leads
with the red tester lead to the brown wire and the
black tester lead to the black/red wire; then turn
the ignition switch to the ON position. The meter
should red battery voltage. If battery voltage is
indicated and the fuel pump does not run, replace
the pump assembly. If no battery voltage is
indicated, check the CDI and the vehicle tilt
sensor.

NOTE: To test the fuel gauge tank sensor, the
fuel pump assembly must be removed.
REMOVING
1. Remove the rear rack and fenders; then disconnect
the power supply/ fuel gauge connector.
KX186
2. Remove the spring clamp; then remove the fuel
hose.
3. Remove the screws securing the fuel pump to the
gas tank; then make a reference mark on the fuel
pump and tank.
KX187
4. Rotate the fuel pump assembly clockwise 90° to
allow removal without removing the fuel tank.
KX188
5. Lift out the fuel pump assembly carefully tilting it
forward to clear the voltage regulator; then guide
the pump and float lever through the opening in
the gas tank.
KX190
6. Using duct tape or other suitable means, cover the
fuel pump opening.
! CAUTION
Take care not to damage the float or float arm or
replacement of the entire assembly will be
necessary.