Arctic Cat 650 Twin2004, Руководство по обслуживанию

Страница: 20 / 210

2-11
2
0736-568
737-686A
To change the lubricant, use the following procedure.
1. Place the ATV on level ground.
2. Remove each oil filler plug.
3. Drain the oil into a drain pan by removing in turn
the drain plug from each.
KX396A
KX395A
4. After all the oil has been drained, install the drain
plugs and tighten to 0.5 kg-m (3.5 ft-lb).
5. Pour the appropriate amount of recommended oil
into each filler hole.
6. Install the filler plugs. Tighten to 2.2 kg-m (16
ft-lb).

NOTE: If the differential/rear drive oil is contami-
nated with water, inspect the drain plug, filler plug,
and/or bladder.
Tires
TIRE SIZES
The ATV is equipped with low-pressure tubeless tires
of the size and type listed. Do not under any circum-
stances substitute tires of a different type or size.
TIRE INFLATION PRESSURE
Front and rear tire inflation pressure should be 0.35
kg-cm² (5.0 psi).
A low-pressure gauge is provided in the tool kit to
measure the air pressure in the tires. Check the air
pressure in all tires before each use of the ATV.
! CAUTION
Water entering the outer end of the axle will not
be able to enter the rear drive unless the seals
are damaged.
! WARNING
Always use the size and type of tires specified.
Always maintain proper tire inflation pressure.