Arctic Cat 650 Twin2004, Руководство по обслуживанию

Страница: 19 / 210

2-10
KX019A
3. Remove the drain plug from the bottom of the
engine and drain the oil into a drain pan.
KX036A
4. Using the Oil Filter Wrench (p/n 0444-042) and
appropriate handle, remove the old oil filter.

NOTE: Clean up any excess oil after removing
the filter.
5. Apply oil to a new filter gasket and check to make
sure it is positioned correctly; then install the new
oil filter. Tighten securely.

NOTE: Install a new filter gasket each time the fil-
ter is replaced.
6. Install the engine drain plug and tighten to 2.0
kg-m (14.5 ft-lb). Pour 2.05 L (2.17 U.S. qt) of the
recommended oil in the filler hole. Install the oil
level stick/filler plug.
7. Start the engine (while the ATV is outside on level
ground) and allow it to idle for a few minutes.
8. Turn the engine off and wait approximately one
minute.
9. Unscrew the oil level stick and wipe it with a clean
cloth.
10. Install the oil level stick and thread into the engine
case.

NOTE: The oil level stick should be threaded into
the case for checking the oil level.
11. Remove the oil level stick; the engine oil level
should be above the illustrated “L” mark but not
higher than the illustrated “F” mark.
ATV0100A
12. Inspect the area around the drain plug and oil filter
for leaks.
Front Differential/Rear
Drive Lubricant
Check and change the lubricant according to the Peri-
odic Maintenance Chart. When changing the lubricant,
use approved SAE 80W-90 hypoid gear lube. To
check lubricant, use the following procedure.
1. Remove each filler plug; the lubricant level should
be 1 in. below the threads of the plug. If low, add
SAE approved 80W-90 hypoid gear lube as neces-
sary.
! CAUTION
Any oil used in place of the recommended oil
could cause serious engine damage. Do not use
oils which contain graphite or molybdenum
additives. These oils can adversely affect clutch
operation. Also, not recommended are racing,
vegetable, non-detergent, and castor-based oils.
!CAUTION
Do not over-fill the engine with oil. Always make
sure that the oil level is above the
“
L” mark but
not higher than the
“
F
”
mark.