Arctic Cat 650 Twin2004, Руководство по обслуживанию

Страница: 133 / 210

6-5
6
4. Loosen the front cap screw; then tighten the cap
screw on the driveshaft side.
AG926

NOTE: It is important to tighten this cap screw
while the others are loose to ensure proper seating
of the actuator.
5. Tighten the remaining cap screws; then connect
the electrical plug to the main harness.
6. Turn the ignition switch to the ON position and
check the operation by shifting the selector switch
several times.
7. Secure the wiring harness to the frame with a
nylon cable tie; then install the inner fender panel.

NOTE: Make sure that the wiring harness is clear
of the exhaust pipe and left-side tie rod.
Front Differential

NOTE: To remove the rear gear case, see Rear
Gear Case in this section.
REMOVING DIFFERENTIAL
1. Secure the ATV on a support stand to elevate the
wheels.
2. Remove the filler plug and the drain plug and
drain the gear lubricant into a drain pan; then
reinstall the plugs.
3. Remove the front wheels.
4. Pump up the hand brake; then engage the brake
lever lock.
5. Remove the cotter pin securing the hex nut; then
remove the hex nut and washer. Release the brake
lever lock.
KX041

NOTE: It is not necessary to remove the brake
hoses from the calipers for this procedure.
6. Remove the brake calipers. Account for the cap
screws.
AF894D
7. Remove the tie rod cotter pins and discard the
pins.
AF895D
8. Remove the tie rod lock nuts.
! WARNING
Make sure the ATV is solidly supported on the sup-
port stand to avoid injury.