Arctic Cat 650 Twin2004, Руководство по обслуживанию

Страница: 69 / 210

3-40
KX328
14. Apply grease to the output drive oil seal; then
install in the housing being careful not to damage
the lip of the seal or distort the seal.
15. Secure the holding fixture (A) in a vise; then
install the driven bevel gear (C), cam damper (D),
spring (E), spring holder (B), and circlip (G).
KX329A
16. Install the guide bars (A), spring compressor (B),
and nuts (C); then tighten the nuts (C) until the
circlip (D) can be installed. After seating the
circlip, remove the nuts (C), compressor (B), and
guide rods (A). Apply grease to the O-ring seal on
the housing.
KX330
KX331A
17. Install the driven gear assembly (B) in the
crankcase; then tighten the four cap screws (A) to
2.7 kg-m (19.5 ft-lb).
KX332
18. Install the drive bevel gear housing (B); then
tighten the four cap screws (A) to 2.7 kg-m (19.5
ft-lb).
KX333

NOTE: If any of the output bevel gear (backlash-
related) parts have been replaced, the Adjusting
Backlash and Adjusting Tooth Contact procedures
must be followed.