Arctic Cat 650 Twin2004, Руководство по обслуживанию

Страница: 108 / 210

5-7
5
RESISTANCE

NOTE: For these tests, the meter selector should
be set to the OHMS position.
Primary Winding
1. Connect the red tester lead to the (+) terminal
(with the wire removed); then connect the black
tester lead to the (-) terminal.
KX201A
2. The meter reading must be within specification.
Secondary Winding
1. Connect the red tester lead to the high tension lead
(plug cap removed); then connect the black tester
lead to ground.
AR601D
2. The meter reading must be within specification.

NOTE: If the meter does not show as specified,
replace ignition coil.
Spark Plug Cap
1. Connect the red tester lead to one end of the cap;
then connect the black tester lead to the other end
of the cap.
AR603D
2. The meter reading must be within specification.

NOTE: If the meter does not read as specified,
replace the spark plug cap.
Ignition Switch
The connector is beneath the front fenders. To access
the connector, the front rack, front fenders, and instru-
ment pod must be removed.
VOLTAGE

NOTE: Perform this test on the lower side of the
connector.
1. Set the meter selector to the D.C. Voltage position.
2. Connect the red meter lead to the red wire; then
connect the black meter lead to ground.
3. Meter must show battery voltage.

NOTE: If the meter shows no battery voltage,
troubleshoot the battery or the main wiring har-
ness.
RESISTANCE

NOTE: Perform this test on the upper side of the
connector.
1. Turn the ignition switch to the ON position.
2. Set the meter selector to the OHMS position.
3. Connect the red tester lead to the red wire; then
connect the black tester lead to the brown wire.
4. The meter must show 980-1020 ohms.
! CAUTION
Always disconnect the battery when performing
resistance tests to avoid damaging the
multimeter.
! CAUTION
Always disconnect the battery when performing
resistance tests to avoid damaging the
multimeter.