Arctic Cat 650 Twin2004, Руководство по обслуживанию

Страница: 175 / 210

8-9
8
AF617D
AF778D

NOTE: The front wheels do not have to be
removed to adjust the tie rod. Also, care should be
taken not to disturb the handlebar position.
8. Using a permanent marker of some type, mark the
center of each front tire (at a height parallel to the
belly panel).
AF789D
9. Measure the overall width of the front tires (at a
height parallel to the belly panel) at the front side;
then record the measurement.
10. Push the ATV forward until the marks are parallel
to the belly panel on the back side; then measure
the overall width of the front tires at the rear side.
CD013
11. The difference in the measurements must show 6.4
mm (1/4 in.) toe-in (the front measurement 6.4
mm (1/4 in.) less than the rear measurement).

NOTE: The 6.4 mm (1/4 in.) toe-in difference is
per side.
12. If the difference in the measurements does not
show a 6.4 mm (1/4 in.) toe-in, adjust both tie rods
equally in until within specification.

NOTE: Prior to locking the jam nuts, make sure
the ball joints are at the center of their normal
range of motion and at the correct angle.
733-559A