Arctic Cat 650 Twin2004, Руководство по обслуживанию

Страница: 112 / 210

5-11
5
Magneto Coil (Trigger)
1. Set the meter selector to the D.C. Voltage position.
2. Connect the red tester lead to the black/white wire;
then connect the black tester lead to the blue wire.
3. Crank the engine over using the electric starter.
4. The meter reading must be within specification.
Magneto Coil (Charging)
1. Set the meter selector to the D.C. Voltage position.
2. Connect the red tester lead to the black wire; then
connect the black tester lead to black wire #1.
3. Crank the engine over using the electric starter.
4. The meter reading must be within specification.

NOTE: Repeat steps 2-4 for black wire #2.
Starter Motor
REMOVING/DISASSEMBLING
1. Disconnect the battery.
2. Remove the nut securing the positive cable to the
starter; then remove the cable from the starter.
3. Remove the two cap screws securing the starter to
the crankcase; then remove the starter. Account for
the wiring forms and an O-ring.
4. For assembly purposes, scribe a line across the
outside of the starter assembly.
AR652D
5. Remove the two long starter cap screws securing
the starter components.
6. Remove the front cover from the starter housing
and armature shaft. Account for a seal protector
and three washers.
BC003
7. Remove the rear cover.
BC005
8. Slide the armature free of the starter housing.
BC006
9. Bend the two positive brushes outward; then
remove the brush holder.
! CAUTION
Always disconnect the negative battery cable
from the battery first; then disconnect the
positive cable.