Arctic Cat 650 Twin2004, Руководство по обслуживанию

Страница: 179 / 210

8-13
8
8. Disconnect the wires from the accessory plug (if
equipped); then remove the accessory plug from
the fender.
9. Remove the fenders from the ATV.
CLEANING AND INSPECTING

NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean all fender components with part-cleaning
solvent and soap and water.
2. Inspect fenders for cracks and/or loose rivets.
3. Inspect for any missing decals.
INSTALLING
1. Place the fenders into position on the ATV.
2. Install the accessory plug (if equipped) into the
fender; then connect the two accessory plug wires.

NOTE: The accessory plug red wire goes on the
center connector.
3. Install the cap screws (five per side) securing the
fenders to the frame and footrests and
finger-tighten; then tighten the ten fasteners
securely.
4. Connect the drive selector linkage using existing
hardware. Tighten securely.
KX057
5. Install the gear shift linkage cover in the left-front
fender well. Tighten securely.
CC851
6. Place the gear shift knob into position on the shift
lever and secure with the retaining pin.
7. Place the side panels into position and secure.
8. Install the front rack (see Front Rack in this
section).
Fender Flares/
Extensions
REMOVING
1. Using a side-cutter, remove the appropriate plastic
rivets.

NOTE: To remove a front extension, first remove
the grille; then remove the push nuts securing the
extension to the bumper.
2. Remove the cap screws securing the extensions or
flares to the frame and footrest.
3. Remove the self-tapping screws securing the
extension to the fender.
INSTALLING
1. Place the flare or extension into position. Using
the Plastic Rivet Setter (p/n 0444-056), secure
with Plastic Rivets (p/n 0423-046) or suitable
substitute.
2. Secure the extensions or flares with the cap screws
and self-tapping screws.