Arctic Cat 650 Twin2004, Руководство по обслуживанию

Страница: 169 / 210

8-3
8
AL618D
CLEANING AND INSPECTING

NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Wash the tie rod ends in parts-cleaning solvent.
Dry with compressed air. Inspect the pivot area for
wear. Apply a low-temperature grease to the ends.
2. Inspect the tie rods for damaged threads or wear.
3. Inspect the tie rods for cracks or unusual bends.
4. Inspect all welded areas for cracks or
deterioration.
5. Inspect the steering post and steering-post brackets
for cracks, bends, or wear.
6. Inspect the bearing halves, bearing caps, and
bearing housings for cracks or wear.
7. Inspect the handlebar tube for cracks, wear, or
unusual bends.
8. Inspect the handlebar grips for damage or wear.
INSTALLING
1. Place the steering post into position; then place the
upper steering post bearings and housings on the
steering post and install the two cap screws
through the housings and into the frame. Tighten
the cap screws to 2.8 kg-m (20 ft-lb).
AL619D
2. Place the handlebar into position and secure with
the handlebar caps (blocks). Tighten the four cap
screws to 2.8 kg-m (20 ft-lb).
KX385
3. Place the ignition switch into position; then place
the instrument pod into position and secure with
the ignition switch retaining nut.
KX386
4. Secure the instrument pod with the four nylon
fasteners.
5. Place the steering post bearing flange into
position. Secure with the cap screws tightened to
2.8 kg-m (20 ft-lb).
! WARNING
Always wear safety glasses when using com-
pressed air.