Arctic Cat 650 Twin2004, Руководство по обслуживанию

Страница: 148 / 210

6-20
7. Remove the tie rod from the steering knuckle.
AF896D
8. Remove the cap screw and lock nut securing the
lower shock eyelet to the upper A-arm. Discard
the lock nut.

NOTE: Never reuse a lock nut. Once a lock nut
has been removed, it must be replaced with a new
lock nut.
9. Remove the cap screw securing the upper A-arm
ball joint to the steering knuckle; then disengage
the ball joint from the knuckle.
10. While holding the drive axle stationary, pull the
top of the steering knuckle out and down until it is
free of the drive axle.
11. Place a drain pan under the ATV to contain any oil
leakage; then using a slide hammer, remove the
drive axle.
AF899D
CLEANING AND INSPECTING

NOTE: Always clean and inspect the drive axle
components to determine if any service or replace-
ment is necessary.
1. Using a clean towel, wipe away any oil or grease
from the axle components.
CD019
2. Inspect boots for any tears, cracks, or
deterioration.

NOTE: If a boot is damaged in any way, it must
be replaced with a boot kit.
DISASSEMBLING AXLES
1. Using a side-cutters (or suitable substitute),
remove the large clamp from the boot.
CD020
2. Wipe away excess grease to access the retaining
ring. Using an awl or circlip pliers, remove the
circlip.
CD021
3. Using a snap ring pliers, remove the circlip
securing the bearing ring to the shaft. Note the
direction of the bearing for assembling purposes.