Arctic Cat 650 Twin2004, Руководство по обслуживанию

Страница: 8 / 210

1-5
1
Preparation
For Storage
Arctic Cat recommends the following procedure to
prepare the ATV for storage.
1. Clean the seat cushion (cover and base) with a
damp cloth and allow it to dry.
2. Clean the ATV thoroughly by washing dirt, oil,
grass, and other foreign matter from the entire
ATV. Allow the ATV to dry thoroughly. DO NOT
get water into any part of the engine or air intake.
3. Either drain the gas tank or add Fuel Stabilizer
(p/n 0638-165) to the gas in the gas tank. Remove
the air filter housing cover and air filter. Start the
engine and allow it to idle; then using Arctic Cat
Engine Storage Preserver (p/n 0636-177), rapidly
inject the preserver into the air filter opening for a
period of 10 to 20 seconds; then stop the engine.
Install the air filter and housing cover.
4. Drain the carburetor float chambers.
5. Plug the exhaust hole in the exhaust system with a
clean cloth.
6. Apply light oil to the upper steering post bushing
and plungers of the shock absorbers.
7. Tighten all nuts, bolts, cap screws, and screws.
Make sure rivets holding components together are
tight. Replace all loose rivets. Care must be taken
that all calibrated nuts, cap screws, and bolts are
tightened to specifications.
8. Fill the cooling system to the bottom of the stand
pipe in the radiator neck with properly mixed
coolant.
9. Disconnect the battery cables; then remove the
battery, clean the battery posts and cables, and
store in a clean, dry area.
10. Store the ATV indoors in a level position.
Preparation After
Storage
Taking the ATV out of storage and correctly preparing
it will assure many miles and hours of trouble-free rid-
ing. Arctic Cat recommends the following procedure
to prepare the ATV.
1. Clean the ATV thoroughly.
2. Clean the engine. Remove the cloth from the
exhaust system.
3. Check all control wires and cables for signs of
wear or fraying. Replace if necessary.
4. Change the engine/transmission oil and filter.
5. On liquid cooled models, check the coolant level
and add properly mixed coolant as necessary.
6. Charge the battery; then install. Connect the
battery cables.
7. Check the entire brake systems (fluid level, pads,
etc.), all controls, headlights, taillight, brakelight,
and headlight aim; adjust or replace as necessary.
8. Tighten all nuts, bolts, cap screws, and screws
making sure all calibrated nuts, cap screws, and
bolts are tightened to specifications.
9. Check tire pressure. Inflate to recommended
pressure as necessary.
10. Make sure the steering moves freely and does not
bind.
11. Check the spark plugs. Clean or replace as
necessary.
12. Follow the recommendations found in the pre-start
inspection.
! CAUTION
Prior to storing the ATV, it must be properly
serviced to prevent rusting and component
deterioration.
! CAUTION
If the interior of the air filter housing is dirty,
clean the area before starting the engine.
! CAUTION
Avoid storing outside in direct sunlight and avoid
using a plastic cover as moisture will collect on
the ATV causing rusting.