Arctic Cat 650 Twin2004, Руководство по обслуживанию

Страница: 22 / 210

2-13
2
TAILLIGHT-BRAKELIGHT
To replace the taillight-brakelight bulb, use the follow-
ing procedure.
1. Remove the two screws and remove the lens
cover.
2. Push the bulb in and turn it counterclockwise.
3. Install the new bulb by turning it clockwise while
pushing in.
4. Install the lens cover.
CHECKING/ADJUSTING HEADLIGHT
AIM
The headlights can be adjusted vertically and horizon-
tally. The geometric center of the HIGH beam light
zone is to be used for vertical and horizontal aiming.
1. Position the ATV on a level floor so the headlights
are approximately 6.1 m (20 ft) from an aiming
surface (wall or similar aiming surface).

NOTE: There should be an average operating
load on the ATV when adjusting the headlight aim.
2. Measure the distance from the floor to the
mid-point of each headlight.
3. Using the measurements obtained in step 2, make
horizontal marks on the aiming surface.
4. Make vertical marks which intersect the horizontal
marks on the aiming surface directly in front of the
headlights.
5. Switch on the lights. Make sure the HIGH beam is
on. DO NOT USE LOW BEAM.
6. Observe each headlight beam aim. Proper aim is
when the most intense beam is centered on the ver-
tical mark 5 cm (2 in.) below the horizontal mark
on the aiming surface.
ATV-0070C
AF926A
7. Adjust each headlight until correct aim is
obtained.
A. Horizontal — Loosen nut (A) and adjust for
proper aiming. Tighten the nut securely.
B. Vertical— Loosen nut (B) and adjust for proper
aiming. Tighten the nut securely.
Switches
Each time the ATV is used, switches should be
checked for proper operation. Use the following list
for reference.
A. Ignition switch — engine will start.
B. Emergency stop switch — engine will stop.
C. Reverse switch — reverse indicator light
illuminates.
D. Hi/Lo switch — headlight beam bright and
dim.
E. Brake switches — rear brakelight illuminates.
Reverse Shift Lever
CHECKING ADJUSTMENT
0736-565
! CAUTION
Tighten the lens cover screws only until they are
snug.