Arctic Cat 650 Twin2004, Руководство по обслуживанию

Страница: 143 / 210

6-15
6
KX175
KX174
11. Making sure the O-ring is properly positioned on
the differential cover, install the differential cover
with existing hardware. Account for the ID tag.
Tighten the cap screws to 2.9-3.5 kg-m (21-25
ft-lb).

NOTE: Grease can be applied to the O-ring for
ease of assembling.

NOTE: If a new gear housing is being installed,
tighten the cap screws to 3.5-4.3 kg-m (25-31 ft-lb).
Removing Needle Bearing

NOTE: Removing the needle bearing is rarely
necessary. Avoid removing the needle bearing
unless the bearing is clearly damaged.

NOTE: This procedure can be performed on a
rear gear case.
1. Place a 6.35 mm (1/4 in.) drill bit on the inside
surface of the needle bearing (against the bottom
side); then drill through the pinion shaft needle
bearing housing.
CC885
2. Using a propane torch, heat the area surrounding
the needle bearing to approximately 300°.
CC886
3. Using a flat-nosed punch, drive the bearing out of
the housing.
CC887
Installing Needle Bearing
1. Place the new bearing into the housing.