Arctic Cat 650 Twin2004, Руководство по обслуживанию

Страница: 57 / 210

3-28
CD058
4. Inspect the pins and bushings for wear, flat spots,
looseness, or cracking.
Assembling
1. Place the fixed face of the driven pulley on the
pulley compressor base making sure the dowel
pins are engaged in the appropriate holes in the
pulley face.
CD048
2. Install the four pins and spacers into the fixed face
hub; then pack the cam slots in the movable face
with multi-purpose grease.
CD061
3. Apply multi-purpose grease to the O-rings and
grease seals on the movable face; then install on
the fixed face making sure the alignment marks
are properly aligned.
CD060
4. Install the spring seat (C), spring (D), spring seat
(E), and circlip (F); then attach the spring holder
(B) and tighten nut (A) until the circlip (F) can be
installed.
KX284A
KX285A
5. Loosen the nut and remove the spring holder; then
remove the driven pulley assembly from the
driven pulley compressor.
DRIVE CLUTCH ASSEMBLY
Disassembling
1. Hold the drive clutch holder in a suitable vise; then
set the clutch on the holder engaging the holding
pins with the clutch back.
2. Remove the drive clutch cover bolts (A); then
remove the clutch cover (B). Account for the
spring and spacers.