Arctic Cat 650 Twin2004, Руководство по обслуживанию

Страница: 91 / 210

4-8
INSTALLING
1. Lay the carburetor on top of the engine; then
install the starter plungers and secure with the
retainer screws.
2. Connect vent lines; then connect the coolant
hoses.
3. Insert the carburetor into the intake tubes making
sure they seat properly; then tighten the clamps
securely.
4. Connect the throttle cable to the throttle actuator
arm; then install the cable into the anchor housing
and tighten the nuts securely.
5. Install the actuator housing cover and secure with
the screws.
6. Connect the hose to the gas tank valve; then
connect the carburetor float chamber drains and
route outlet hose behind engine.
7. Install the air filter housing onto the carburetors
and secure with eight cap screws; then install the
air filter, filter housing cover, and storage
compartment cover.
Throttle Cable
Free-Play
1. Check throttle cable free-play at the lever;
free-play should be 3-6 mm (1/8 - 1/4 in.).
2. To adjust, slide the rubber boot away from the
adjuster located near the throttle lever. Loosen the
jam nut and rotate the adjuster in the appropriate
direction until proper free-play is attained. Tighten
the jam nut against the adjuster; then slide the
rubber boot over the adjuster.
ATV-0047
Engine RPM (Idle)
To properly adjust the idle RPM, a tachometer is nec-
essary.
To adjust idle RPM, use the following procedure.
1. Start the engine and warm it up to operating
temperature.
2. Turn the idle adjustment screw clockwise or
counterclockwise until the engine idles at
1050-1150 RPM.
KX029A
! WARNING
Adjust the idle to the correct RPM. Make sure the
engine is fully warm before adjusting the idle RPM.