Arctic Cat 650 Twin2004, Руководство по обслуживанию

Страница: 37 / 210

3-8
KX242
11. Remove the cap screws securing the oil pump (A);
then remove the oil pump drive chain (B) and oil
pump assembly (C).
KX243
Right-Side Components

NOTE: For efficiency, it is preferable to remove
and disassemble only those components which
need to be addressed and to service only those
components. The technician should use discretion
and sound judgment.

NOTE: The engine/transmission does not have
to be removed from the frame for this procedure.
Removing Right-Side
Components
A. V-Belt Cover
B. Driven Pulley
C. Clutch Assembly
1. Turn the ignition switch to the OFF position and
remove the ignition key.
2. Loosen the two clamps (A) securing the air duct
boot (B); then remove the boot.
KX244
3. Disconnect the drive belt failure detection
connector and the engine brake actuator lead; then
remove the cap screws securing the V-belt cover to
the crankcase.

AT THIS POINT
To service any one specific component, only
limited disassembly of components may be
necessary. Note the AT THIS POINT information
in each sub-section.
! WARNING
Imbalance of clutch or driven pulley or excessive
RPM could cause component failure resulting in
severe injury or death. These components are
precision balanced and designed to operate
within certain RPM limits. Disassembling,
assembling, and servicing procedures of clutch
and driven pulley must be followed closely. Any
modifications that increase RPM may cause fail-
ure.
! CAUTION
Do not turn the ignition switch ON while the
V-belt cover is removed. This will cause the
learning control of the engine brake control to
operate and the engine brake actuator may be
damaged.