Alcatel-Lucent 060321-10, Rev. B, Справочное руководство CLI

Страница: 544 / 2354

show arp filter IP Commands
page 10-126 OmniSwitch CLI Reference Guide March 2011
show arp filter
Displays a list of ARP filters configured for the switch.
show arp filter [ip_address]
Syntax Definitions
ip_address IP address of the filter entry you want to view.
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
If an IP address is not specified with this command, a list of all ARP filters is displayed.
•
Enter a specific IP address to view the configuration for an individual filter.
Examples
-> show arp filter
IP Addr IP Mask Vlan Type Mode
-----------------+-------------------+------+----------+-------
171.11.1.1 255.255.255.255 0 target block
172.0.0.0 255.0.0.0 0 target block
198.0.0.0 255.0.0.0 0 sender block
198.172.16.1 255.255.255.255 200 target allow
-> show arp filter 198.172.16.1
IP Addr IP Mask Vlan Type Mode
-----------------+-------------------+------+----------+-------
198.0.0.0 255.0.0.0 0 sender block
198.172.16.1 255.255.255.255 200 target allow
output definitions
IP Addr The ARP packet IP address to which the filter is applied.
IP Mask The IP mask that specifies which part of the IP address to which the fil-
ter is applied.
Vlan A VLAN ID. The filter is applied only to ARP packets received on
ports associated with this VLAN.
Type Indicates which IP address in the ARP packet ( sender or target ) is
used to identify if a filter exists for that address.
Mode Indicates whether or not to block or allow a switch response to an ARP
packet that matches the filter.