Alcatel-Lucent 060321-10, Rev. B, Справочное руководство CLI

Страница: 1701 / 2354

QoS Policy Commands policy condition source udp-port
OmniSwitch CLI Reference Guide March 2011 page 26-61
policy condition source udp-port
Configures a source UDP port number for a policy condition.
policy condition condition_name source udp-port port[-port]
policy condition condition_name no source udp-port
Syntax Definitions
condition_name The name of the condition.
port The UDP port number of the source address of the Layer 3 flow, in the
range from 0–65535. A range of ports (separated by a hyphen) may be
specified instead of a single port.
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of the command to remove a source UDP port from a condition; however, at least one
classification parameter must be associated with a condition.
•
This command is a shortcut for the policy condition source ip-port command, which requires that the
protocol also be specified. Rather than specifying source ip port and ip protocol , use source udp-
port .
•
The same condition cannot specify a source UDP port with a service or service group.
•
IP port protocol types cannot be mixed in the same condition; ports must be either TCP or UDP.
•
Use this condition in combination with the IPv6 condition ( policy condition ipv6 ) to configure IPv6
policies for Layer 4 information, services, and service groups.
Examples
-> policy condition cond5 source udp-port 1200-1400
-> policy condition cond6 ipv6 source-udp port 1000
-> policy condition cond5 no source udp-port
Release History
Release 7.1.1; command was introduced.