Alcatel-Lucent 060321-10, Rev. B, Справочное руководство CLI

Страница: 1573 / 2354

QoS Commands qos phones
OmniSwitch CLI Reference Guide March 2011 page 25-13
qos phones
Enables or disables the automatic prioritization of IP phone traffic.
qos phones [priority priority_value | trusted]
qos no phones
Syntax Definitions
priority_value The priority given to scheduling traffic on the output port. Values range
from 0 (lowest) to 7 (highest).
trusted Trusts IP phone traffic; priority value of the IP phone packet is used.
Defaults
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to disable automatic prioritization of IP phone traffic.
•
IP phone traffic is identified by examining the source MAC address of the packet received on the port.
If the source MAC falls within one of the following ranges, the QoS IP phone priority is automatically
assigned to the MAC:
00-80-9F-54-xx-xx to 00-80-9F-64-xx-xx
00-80-9F-66-xx-xx to 00-80-9F-6F-xx-xx.
•
To automatically apply the QoS IP phone priority to other, non-IP phone traffic, add the source MAC
addresses of such traffic to the QoS “alaPhone” group.
•
When automatic prioritization of IP phone traffic is enabled, QoS policies that specify priority are not
applied to the IP phone traffic. Other QoS policies, however, are applied to this type of traffic as usual.
Examples
-> qos phones priority 7
-> qos phones trusted
-> qos no phones
Release History
Release 7.1.1; command was introduced.
parameter default
priority_value | trusted trusted