Alcatel-Lucent 060321-10, Rev. B, Справочное руководство CLI

Страница: 587 / 2354

IPv6 Commands traceroute6
OmniSwitch CLI Reference Guide March 2011 page 11-27
traceroute6
Finds the path taken by an IPv6 packet from the local switch to a specified destination. This command
displays the individual hops to the destination as well as some timing information.
traceroute6 { ipv6_address | hostname } [ if_name ] [max-hop hop_count] [dest-port port_number]
[probe-count probe] [size size] [host-names { yes|no } ]
Syntax Definitions
ipv6_address Destination IPv6 address. IPv6 address of the host whose route you
want to trace.
hostname DNS name of the host whose route you want to trace.
if_name If the target is a link-local address, the name of the interface used to
reach it.
hop_count Maximum hop count for the trace.
port Specific UDP port destination. By default, the destination port is chosen
by traceroute6.
size The initial size for the probe packets. During the trace the packet size
will be adjusted downward as path MTU information is received. The
default and maximum value is 24,000 bytes with a minimum of 1,280
bytes.
host-names Specify whether each hop should be shown as an IPv6 address or the
host name corresponding to the address.
probe Number of probes to be sent to a single hop.
Defaults
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
When using this command, you must enter the name of the destination as part of the command line
(either the IPv6 address or hostname).
•
Use the optional max-hop parameter to set a maximum hop count to the destination. If the trace
reaches this maximum hop count without reaching the destination, the trace stops.
Examples
-> traceroute6 41EA:103::65C3
parameter default
hop_count 32
probe 3
host-names no