Alcatel-Lucent 060321-10, Rev. B, Справочное руководство CLI

Страница: 1269 / 2354

IP Multicast Switching Commands ip multicast vlan max-group
OmniSwitch CLI Reference Guide March 2011 page 21-11
ip multicast vlan max-group
Configures the maximum group limit learned per port on a VLAN. The limit is applied to each port that is
a member of the given VLAN.
ip multicast vlan vid max-group [num] [action {none | drop | replace}]
Syntax Definitions
vid VLAN on which to apply the configuration.
num The maximum IGMP group count. Valid range is 0 to 4294967295.
none Disables the maximum group limit configuration.
drop Drops the incoming membership request.
replace Replaces an existing membership with the incoming membership
request.
Defaults
By default, the max-group limit is set to zero.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Configuring a max-group value will have no affect on existing group memberships until the member-
ships are refreshed on the port/VLAN instance
•
The configuration is allowed even when the ip multicast status is disabled.
•
If the num and action parameters are not specified, then the limit is removed.
•
The max-group configuration on a VLAN will override the global configuration.
•
IGMP zapping must be enabled when the max-group limit is enabled and the action is dropped.
Examples
-> ip multicast vlan 10 max-group 10 action drop
-> ip multicast vlan 10 max-group
Release History
Release 7.1.1; command was introduced.
parameter defaults
Action none