Alcatel-Lucent 060321-10, Rev. B, Справочное руководство CLI

Страница: 2134 / 2354

ntp peer Network Time Protocol Commands
page 40-20 OmniSwitch CLI Reference Guide March 2011
ntp peer
Configures NTP to operate in the symmetric active peering mode.This also enables the establishment of an
active symmetric association with the specified remote peer.
ntp peer {ip-address} [key keyid] [version version] [minpoll poll interval]
no ntp peer {ip-address}
Syntax Definitions
ip-address IP address of the remote peer.
key-id Authentication key for the remote peer.
version NTP packet version to be used for the peer association.
poll interval Polling interval for NTP broadcast message. Poll interval which when
expires, packets will be sent to the peer.
Defaults
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use no form of this command to remove the peers that are configured to act in symmetric active
mode.This command deletes the symmetric active association with the remote peer.
•
Use the version keyword to set the correct version of NTP.
•
Use the minpoll keyword to set the minimum poll time for the server. This number is determined by
raising 2 to the power of the number entered.
•
The command should not be used for b(Broadcast ), m(Multicast) or r(Reference clock address
127.127.x.x)
•
ip-address is the mandatory parameter to be entered in the command while key id is the optional
parameter. If key id is not specified, then peering will not be authenticated.
Examples
-> ntp peer 172.18.16.112
-> no ntp peer 172.18.16.112
Parameter Default
version 4
poll interval 6