Alcatel-Lucent 060321-10, Rev. B, Справочное руководство CLI

Страница: 643 / 2354

IPv6 Commands ipv6 rip interface send-status
OmniSwitch CLI Reference Guide March 2011 page 11-83
ipv6 rip interface send-status
Configures IPv6 RIPng interface “Send” status. When this status is set to "enable", packets can be sent
from this interface. When it is set to "disable", packets will not be sent from this interface.
ipv6 rip interface if_name send-status {enable | disable}
Syntax Definitions
if name IPv6 interface name.
enable | disable Interface “Send” status.
Defaults
Platforms Supported
OmniSwitch 10K
Usage Guidelines
RIPng must be loaded ( ipv6 load rip ) and enabled ( ipv6 rip admin-state )on the switch to send or receive
packets on the interface.
Examples
-> ipv6 rip interface Test_Lab send-status enable
Release History
Release 7.1.1; command was introduced.
Related Commands
MIB Objects
alaRipngInterfaceTable
alaRipngInterfaceSendStatus
parameter default
enable | disable enable
ipv6 redist Loads RIPng into memory.
ipv6 rip admin-state Enables/disables RIPng on the switch.
ipv6 rip interface recv-status Configures IPv6 RIPng interface “Receive” status.