Unox BakerTop XBC 1005, Instruction Manual

Page: 29 / 338

English
BakerTop
™
ChefTop
™
Warning messages (attention) panel control board:
Display message Description Effect Problem solution
WD10
Non basic control board
setting error
The oven keeps on working (with
some limitations due to the setting
involved on the error)
Contact the Customer
Assistance Service
Alarm messages:
When a condition arises which prevents the appliance from operating at all, an ALARM signal is displayed and
the appliance must be switched to its STOP status.
The device stops operating and the ALARM! message appears on the oven display until the problem is resolved.
If the device is operating when the ALARM status occurs, it will shut down and the alert corresponding to the
detected problem will be displayed.
To resolve a problem of this type, contact an Authorised Assistance Centre.
Once the problem has been resolved, the appliance can be reactivated by pressing the "START/STOP"
button.
If any other devices/accessories are connected to the oven, these will continue to operate normally unless the
alarm corresponds to a specific device that prevents its continued operation.
Alarm messages oven:
Display message Description Effect Problem solution
AF01
The motors have overheated Oven shutdown Contact the Customer Assistance Service
AF02
The safety thermostat has
overheated
Oven shutdown Contact the Customer Assistance Service
AF03
An error has been detected
in the data recorded by both
cavity probes
Oven shutdown Contact the Customer Assistance Service
AF04
Communication between the
control P.C.B. and the power
P.C.B. has been cut off
Oven shutdown Contact the Customer Assistance Service
AF05
Communication between the gas
P.C.B and the power P.C.B. has
been cut off
Oven shutdown Contact the Customer Assistance Service
AF06
Gas oven exhaust fumes reach too
high temperature
Oven shutdown Contact the Customer Assistance Service
AF10
Power card settings error Oven shutdown Contact the Customer Assistance Service
GAS
There is no flame in the
burner
The burner is deactivated. Ignition
may be attempted again by ressing
the “START/STOP” button
In case it is not possible to re-start the oven,
immediately close the gas cock
N.B.
Every time the oven is started electrically, and every time the control P.C.B. exits STANDBY mode, the control
P.C.B. is scanned for ALARM / WARNING conditions (which appear on the display, if present).
Oven-user communication
29