Toshiba e-STUDIO200L, Service Manual

Page: 304 / 708

e-STUDIO200L/202L/230/232/280/282 ADJUSTMENT June 2004 © TOSHIBA TEC
3 - 8
(6) After the adjustment for the code 411 is completed, apply the same adjustment value for the
code 410.
(Adjustment Mode) # (Key in the code [410]) # [START]
# (Key in the same value in the step 5 above)
# Press [ENTER] or [INTERRUPT] (Stored in memory).
Note: Note:
Make sure the first line of the grid pattern is printed out since the line is occasionally vanished.
[C] Reproduction ratio of secondary scanning direction (Fine adjustment of main motor rotation speed
(Copier/Printer))
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON. # (Adjustment mode)
(2) Press [1] # [FAX]. (A grid pattern with 10 mm squares is printed out. Use A3/LD from standard
drawer of the equipment (Refer to *).
*Perform 08-477 and check the value.
If the value is 0, use the lower drawer.
If the value is 1, use the upper drawer.
(3) Check the grid pattern on the test chart printed out and measure the distance C from the 10th
line at the leading edge of the paper to the 30th line of the grid pattern.
*Normally, the 1st line of the grid pattern is not printed.
(4) Check if the distance C is within 200±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance C again.
(Adjustment Mode) # (Key in code [421]) # [START]
# (Key in a value (acceptable values: 0 to 255))
# [ENTER] or [INTERRUPT] (Stored in memory)
# “100% A” is displayed
# Press [1] # [FAX] # (A grid pattern is printed out.)
*The larger the adjustment value is, the longer the distance C becomes (approx. 0.125 mm/step).
04/09