Toshiba e-STUDIO200L, Service Manual

Page: 469 / 708

June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING
5 - 39
5
[EA30] Power-ON jam
MJ-1022
Is there any paper remaining on the transport path in the finisher?
#
YES Remove the paper.
NO
Is the connector J10 on the finisher controller PC board disconnected?
Is the harness connecting the finisher controller PC board and inlet sensor (S2) open cir-
cuited?
#
YES Connect the connector securely. Replace the harness.
NO
Is the inlet sensor working properly? (Check the movement of the actuator.)
l
l
#
NO 1) Connect the connector of the inlet sensor securely.
2) Attach the actuator securely if its shaft is out of place.
3) Replace the inlet sensor.
YES
Replace the finisher controller PC board.
MJ-1025
Is there any paper remaining on the transport path in the finisher or equipment?
#
YES Remove the paper.
NO
Is the connector CN16 (inlet sensor, folding position sensor) on the finisher controller PC
board disconnected?
Is the connector J1007 (photosensor PC board) on the punch controller PC board discon-
nected?
Is the harness between the finisher controller PC board and each sensor (inlet sensor, fold-
ing position sensor, and punch controller PC board open-circuited?
Is the harness connecting the punch controller PC board and photosensor PC board open-
circuited?
#
YES Connect the connector securely. Replace the harness.
NO
Are the inlet sensor and holding position sensor working properly?
Is the photosensor PC board working properly?
l
#
NO 1) Attach the actuator securely if its shaft is out of place.
2) Replace the sensor.
YES
Replace the finisher controller PC board.
Replace the punch controller PC board.