Toshiba e-STUDIO200L, Service Manual

Page: 433 / 708

June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING
5 - 3
5
[E090] Paper jam by HDD abnormality
(1) Check if the error is cleared by turning the power OFF and then back ON.
(2) Check if the connectors of the HDD are disconnected.
(3) Check if the connector pins are disconnected and the harnesses are open circuited.
(4) Replace the HDD.
(5) Replace the SYS board.
[E200] Paper fed from the upper drawer not reaching the registration sensor
[E210] Paper fed from the lower drawer not reaching the registration sensor
[E300] Paper fed from the PFP upper drawer not reaching the registration sensor
[E330] Paper fed from the PFP lower drawer not reaching the registration sensor
[E3C0] Paper fed from the LCF not reaching the registration sensor
Open the transfer cover. Is there paper in front of the registration sensor?
#
YES Remove the paper.
NO
Is the registration sensor working?
(Perform the input check in the test mode: 03-[FAX]ON/[2]/[A]
l
l
l
l
l
l
l
l
#
NO 1) Check if the connector of the registration sensor is disconnected.
2) Check if the connector CN305 on the LGC board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are
open circuited.
4) Check if the conductor pattern on the LGC board is short circuited or
open circuited.
5) Replace the registration sensor.
6) Replace the LGC board.
YES
Are the (lower/middle) transport clutches working?
(Perform the output check in the test mode: 03-203, 205)
l
l
l
l
l
l
l
l
l
#
NO 1) Check if the connectors of the (lower/middle) transport clutches are
disconnected.
2) Check if the connector CN305 on the LGC board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are
open circuited.
4) Check if the conductor pattern on the LGC board is short circuited or
open circuited.
5) Replace the (lower/middle) transport clutches.
6) Replace the LGC board.
YES
1) Check the condition of the feed roller, separation roller and pickup roller of each paper
source, and replace them if they are worn out.
2) Check the transport roller. Replace it if it is worn out.