Toshiba e-STUDIO200L, Service Manual

Page: 440 / 708

e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING June 2004 © TOSHIBA TEC
5 - 10
Relation between the jamming area and the corresponding sensors/covers
(If a jam is occurring in the ADU, LCF, PFP, JSP or OCT check the board in each unit.)
[E550] Paper remaining on the transport path
Open the cover of the unit/area whose picture is blinking on the control panel. Is there any
paper on the transport path?
#
YES Remove the paper.
NO
Is the sensor in the jamming area working? (Perform the input check in the test mode: refer
to the following table)
l
l
l
l
l
l
l
l
#
NO 1) Check if the connector of the sensor is disconnected.
2) Check if any of the connectors on the LGC board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are
open circuited.
4) Check if the conductor pattern on the LGC board is short circuited or
open circuited.
5) Replace the sensor.
6) Replace the LGC board.
YES
Replace the LGC board.
Jamming area Cover Sensor Test mode/Input check
Registration area Transfer cover Registration sensor 03-[FAX]ON/[2]/[A]
1st transport sensor 03-[FAX]OFF/[6]/[E]
Exit area Transfer cover Exit sensor 03-[FAX]ON/[2]/[B]
ADU ADU ADU entrance sensor 03-[FAX]OFF/[1]/[H]
ADU exit sensor 03-[FAX]OFF/[1]/[G]
Feeding area
(Main unit) Side cover 2nd transport sensor 03-[FAX]OFF/[7]/[E]
LCF LCF side cover LCF feed sensor 03-[FAX]OFF/[5]/[G]
PFP PFP side cover PFP upper drawer feed sensor 03-[FAX]OFF/[2]/[D]
PFP lower drawer feed sensor 03-[FAX]OFF/[4]/[D]
Bridge unit Bridge unit Bridge unit transport sensor-1 03-[FAX]ON/[3]/[H]
Bridge unit transport sensor-2 03-[FAX]ON/[3]/[E]
JSP JSP cover JSP feed sensor 03-[FAX]ON/[3]/[H]
OCT OCT cover OCT feed sensor 03-[FAX]ON/[3]/[H]
Finisher Finisher door Sensors in the finisher -