Toshiba e-STUDIO200L, Service Manual

Page: 424 / 708

e-STUDIO200L/202L/230/232/280/282 PREVENTIVE MAINTENANCE (PM) June 2004 © TOSHIBA TEC
4 - 24
* j1. Separation fingers for fuser roller
The paper jam may be caused if the tip of the finger is damaged or deformed. If there is
any problem with it, replace the finger with a new one regardless of the number of output
pages which have been made. Do not damage the tip of the finger during the cleaning.
The finger may be damaged if the toner adhering to the tip of it is scraped off forcibly.
Replace the finger if the toner is sticking to it heavily.
* j2. Thermistor
Clean the thermistor with alcohol if the toner or dirt is sticking to it when the fuser roller is
replaced.
Do not deform or damage the thermistor during the cleaning. Replace the thermistor with a
new one if it is damaged or deformed regardless of degree.
* o1. Idling roller
Apply one-rice-grain-amount of white grease (Molykote X5-6020) to each part A in the fig-
ure below.
Fig. 4-19
* p1. OCT separator roller
Apply one-rice-grain-amount of FLOIL (GE-334C) to the part A in the figure below. Also
apply three-rice-grain-amount of white grease (Molykote X5-6020) to each part B.
Fig. 4-20
A
B
B
A